Split off from https://www-secure.symantec.com/connect/forums/flag-status-unknown as unrelated question:
Thanks again Mike and Gaurav .
I am facing one more issue when i am trying to switch the resource group from node1 to node2 and getting attached error for the nfs mount point.Also attaching update main.cf.
So can you please suggest the solution to this problem as well.
Below is the nfs export and fstab file entry on node1 ,node2.
[root@node1 ~]# cat /etc/exports
/nfsshr01 *(rw,sync,no_root_squash)
[root@node1 ~]#
[root@node1 ~]# cat /etc/fstab
/dev/VolGroup00/LogVol00 / ext3 defaults 1 1
LABEL=/boot /boot ext3 defaults 1 2
tmpfs /dev/shm tmpfs defaults 0 0
devpts /dev/pts devpts gid=5,mode=620 0 0
sysfs /sys sysfs defaults 0 0
proc /proc proc defaults 0 0
/dev/VolGroup00/LogVol01 swap swap defaults 0 0
# NOTE: When adding or modifying VxFS or VxVM entries, add '_netdev'
# to the mount options to ensure the filesystems are mounted after VxVM and
# VxFS have started.
192.168.56.121:/nfsshr01 /nfslock nfs defaults 0 0
[root@node1 ~]#
[root@node2 ~]# cat /etc/fstab
/dev/VolGroup00/LogVol00 / ext3 defaults 1 1
LABEL=/boot /boot ext3 defaults 1 2
tmpfs /dev/shm tmpfs defaults 0 0
devpts /dev/pts devpts gid=5,mode=620 0 0
sysfs /sys sysfs defaults 0 0
proc /proc proc defaults 0 0
/dev/VolGroup00/LogVol01 swap swap defaults 0 0
# NOTE: When adding or modifying VxFS or VxVM entries, add '_netdev'
# to the mount options to ensure the filesystems are mounted after VxVM and
# VxFS have started.
192.168.56.121:/nfsshr01 /nfslock nfs defaults 0 0
[root@node2 ~]#
When trying to do manually getting below error for mount point under vcs.
[root@node2 ~]# mount -t vxfs /dev/vx/dsk/nfsvdg01/nfsvol01 /nfsshr01
UX:vxfs mount.vxfs: ERROR: V-3-22168: Cannot open portal device: No such file or directory
UX:vxfs mount.vxfs: ERROR: V-3-25255: mount.vxfs: You don't have a license to run this program
[root@node2 ~]#